2025 911 GT3 · Type 992.2 · Europe

911 transmissions

Upshift · 1st to 2ndIn 1st gear

Drag either cutaway to turn both.

Driver operated

Six-speed manual

H-pattern stick · Clutch pedal · One drive clutch

Manual transmission components with a clutch pedal, gear stick, flywheel, clutch and gear train.
Stick
1st gear
Clutch
Clamped

Porsche data (PDF)

How the clutch pedal reaches the gearbox

Side section of the manual clutch and its hydraulic pedal circuit The pedal moves the master piston. A fluid line connects it to the release cylinder and bearing. The bearing acts on the spring, which controls how firmly the flywheel and pressure plate grip the disc. The disc hub fits the gearbox input shaft. Clutch pedalMaster cylinderHydraulic line Pressure released FlywheelPressure plate Spring Release cylinder Friction discRelease bearing Input shaft EngineGearbox
Hydraulic circuitTorque connectionClearances enlarged

How the gear stick selects a gear

From the H-pattern gear stick to the synchronizer sleeve Moving sideways in neutral pulls or pushes the select cable to choose one of three rails. Moving the stick forward or back operates the shift cable. The selected rail moves a fork and sleeve. A friction ring matches speeds before the sleeve engages the gear’s dog teeth and locks it to the shaft. H-pattern stickSelector rails 135246 Select cableShift cable 1–2 3–4 5–6 1st and 2nd on one shaftSelector fork 1st gear2nd gear ShaftSleeve Dog teethSplined hubSynchronizer ring
Side to sideForward and backTravel enlarged

Computer controlled · Drive

Seven-speed PDK

Porsche Doppelkupplung · Two wet clutches · Two input shafts

PDK cutaway showing the control unit wired to the solenoid bank and two pressure lines leading to the twin-clutch housing.
Controller · DPreselect 2nd on K2

Accelerating · road speed rising

Porsche data (PDF)

Inside the PDK solenoid bank

The two silver lines above show the pressure feeds for K1 and K2. Their routing is schematic. Inside each clutch-pressure valve, the controller varies the coil current. The magnetic field pulls an armature that moves the spool against a spring, metering oil to the clutch piston. With the coil off, oil drains back to the sump.

Clutch pressure solenoid in longitudinal section Two electrical terminals feed the fixed coil around the moving armature. A pin links the armature to the spool. Spool travel connects the clutch to the pump or the sump. The shaded oil around the narrow middle of the spool also feeds the pressure feedback passage to the spring chamber. Two-pin connector to the PDK controller CoilIron armature Valve spoolReturn spring Pressure feedback SumpOil pump Clutch pistonFriction plates Coil currentSteady Clutch pressureHeld
K1 · 1st gearRepresentative normally-low valveTravel enlarged